|  My account  |  Shopping cart
Shopping cart   Your shopping cart is empty
 
ProductsFind a TunerBecome a TunerWork for usTuner ShopOEMsSupportDownloadsAbout
 
banner01.jpg
 

Data Logging

LIVE DATA analysis is an invaluable tool and when it's combined with powerful data-logging software this makes ProECU Diagnostic Tools truly special.

During live data capture four selectable graphs can be displayed, though all analogue input channels can be logged for later analysis.



As an example, the following analogue data may be retrieved from a 2002 Impreza WRX:

  • Coolant Temperature
  • Air Fuel Correction
  • Air Fuel Learning
  • Manifold Absolute Pressure
  • Engine Speed
  • Vehicle Speed
  • Ignition Timing
  • Intake Air Temperature
  • Mass Air Flow
  • Throttle Opening Angle
  • Rear O2 Sensor
  • Battery Voltage
  • Air Flow Sensor Voltage
  • Throttle Sensor Voltage
  • Fuel Injector Pulse Width
  • Knock Correction
  • Atmospheric Pressure
  • Manifold Relative Pressure
  • Fuel Level
  • Primary Wasetgate Duty Cycle
  • CPC Valve Duty
  • Tumble Valve Position Sensor Left
  • Tumble Valve Position Sensor Right
  • Idle Speed Control Valve Duty
  • Fuel Pump Duty
  • Air/Fuel Sensor Current
  • Air/Fuel Sensor Resistance
  • Air/Fuel Sensor Voltage
  • Rear O2 Heater Voltage
  • Air/Fuel Sensor Heater Current
  • Exhaust Gas Temperature
 

The following digital data may be obtained from the same car:

  • AT Vehicle ID
  • Test Mode Connector
  • Neutral Position Switch
  • Idle Switch
  • Ignition Switch
  • Power Steering Switch
  • Air Conditioning Switch
  • Starter Switch
  • Rear O2 Rich Signal
  • Knock Signal
  • Crank Position Sensor
  • Cam Position Sensor
  • Defogger Switch
  • Blower Switch
  • Interior Light Switch
  • Air-Con Compressor Signal
  • Radiator Fan Relay 1
  • Radiator Fan Relay 2
  • TGV Output
  • TGV Drive#
  • Torque Control Signal 1
  • Torque Control Signal 2
  • Torque Permission Signal
 

There is no need to set up lo-file names. The file is generated within your specified directory ‒ one click and you are logging as many channels as you like.

A typical log-file lasting five minutes and capturing eight channels of data is only 150kb. A very fast log of three channels lasting 30 seconds (one power run) will create a dated and timed file of less than 20kb.

Having created the log file, you can imported it to DeltaDash and view it as graphs or real data. Within the graphing option we allow zooming of any area on any channel, allowing detailed analysis of sections of the graph down to less than 0.01sec.

The data option allows you to look at each channel, and these channel outputs are displayed as real numbers (in ms, degrees, kp/h etc). The logged data-file is created as a .csv file which can be accessed and edited within any spreadsheet program.

 

Get in Touch